How should I properlly draw on a schematic shunt going through center of a toroid coil? – electronics.stackexchange.com

How should I properlly draw on a schematic shunt going through center of a toroid coil? – electronics.stackexchange.com

14:42 No Comments
So I'm trying to reverse engineer the schematic for Avair AV-200CN SWR bridge. Two toroid coils, used for sensing, are mounted on a shunt, so that the shunt goes through the center of the coils. I'm ...

from Hot Questions - Stack Exchange OnStackOverflow
via Blogspot

Share this

Unknown

Artikel Terkait

0 Comment to "How should I properlly draw on a schematic shunt going through center of a toroid coil? – electronics.stackexchange.com"

Post a Comment

Subscribe to: Post Comments (Atom)