Is there any way to make a drill hole only up to half depth of PCB in Eagle – electronics.stackexchange.com

Is there any way to make a drill hole only up to half depth of PCB in Eagle – electronics.stackexchange.com

03:04 No Comments
I need to solder a through hole zigbee as though it were an smd part. The other side of the board is a touch pad so there should not be any solder or components on it. I think it is better if I can ...

from Hot Questions - Stack Exchange OnStackOverflow
via Blogspot

Share this

Unknown

Artikel Terkait

0 Comment to "Is there any way to make a drill hole only up to half depth of PCB in Eagle – electronics.stackexchange.com"

Post a Comment

Subscribe to: Post Comments (Atom)